Stove Operation; First Startup; Everyday Startup; Running Out Of Pellets - Enerzone EUROSTAR Installation And Operation Manual

7 STOVE OPERATION

7.1 First Startup

Before starting your stove, make sure that the burn pot, the baffles and the maintenance access
panels are properly installed. Also make sure that venting system is properly sealed and all doors
are closed. Make sure the hopper is full; the hopper lid is closed and select the desired mode
(manual or thermostat).
Press the auger icon on the Main Status Page followed by "FEED AND START" button in
the displayed page.
If fire doesn't start within 20 minutes, a warning code will appear. Refer
to troubleshooting section for more details.
WARNING: NEVER USE A GRATE OR OTHER MEANS OF SUPPORTING THE FUEL. ONLY
USE THE STOVE APPROVED BURN POT.

7.2 Everyday Startup

Before starting the stove, make sure there is enough pellets in the hopper and that the
recommended maintenance schedule has been followed (see Section 8.1.1 Recommended
maintenance schedule) then press the "ON/OFF" icon on the main status page.

7.3 Running Out of Pellets

If your stove runs out of pellets, the fire will slowly go out; the convection fan will run until the heat
sensor on the exhaust fan reads 115°F. The cooling cycle will take a few minutes before all other
motors stops. When this temperature is reached, a warning message "NO FUEL" will be displayed
on the LCD screen.
To restart the stove, wait until all component stops running (usually 10 minutes after the warning
message has been displayed). Press the "RESET" button, refill the hopper, and press the auger
icon on the Main Status Page followed by "FEED AND START" button in the displayed
page.

7.4 Refilling

While the stove is running, you have up to 3 minutes to refill pellets in the hopper. Note that
opening the hopper lid will stop the auger from feeding pellets to the stove. If the hopper lid is left
open more than 3 minutes, the stove will stop and a warning code ''HOPPER LID OPEN'' will
appear on the LCD screen. To restart the stove, close the lid, press the "RESET" button, and then
press the "ON/OFF" icon on the Main Status Page.
NOTE: Keep hopper lid closed at all times except when refilling. Do not overfill the hopper.
Eurostar Installation and Operation Manual 35