Enerzone EUROSTAR Installation And Operation Manual page 68

Here is an example of what your thermostat could look like:
Connect one wire on "RH" and the other wire on "W". Red wire jumper can be left installed. For
further information refer to the manufacturer's instructions.
Wireless thermostat
If you are using a wireless thermostat or a hand held thermostatic remote control, connect the two
thermostat wires to the terminal block located at the rear on the right hand side of the stove while
facing it. If the receiver wires are equipped with quick-connect terminals you can connect them
directly to the stove's wiring harness.
To do so, open the right hand side decorative panels and disconnect the two (2) harness wires
attached to the rear of the terminal block and connect them to the receiver wires.
68
QUICK CONNECT
TERMINALS
Eurostar Installation and Operation Manual