Through An Existing Masonery Fireplace - Enerzone EUROSTAR Installation And Operation Manual

4.5.5 Through an Existing Masonery Fireplace

Position stove, following clearances shown
1.
in Section 3.2 Minimum Clearances to
Combustibles
manufacturer's instructions.
2. Build and Install a blocking plate inside the
chimney to seal the fireplace damper.
Stainless steel plate and screws are
recommended. Cut a hole for the exhaust
pipe. If needed, cut a second hole for the air
intake pipe (see Appendix F: Combustion
Air Supply).
3. Attach a section of pipe and clean out tee to
the exhaust, making sure the clean out tee
is centered in the chimney flue area.
4. Build and install
fireplace. Stainless steel plate and screws
are recommended. Cut a hole for the vent
pipe. If needed, cut a second hole for the air
intake pipe. Seal all joints with high
temperature waterproof silicone sealant to
prevent water leakage.
5. Seal and install vertical roof vent. If
required, seal and install a storm collar.
NOTE: THE STRUCTURAL CONDITION OF THE MASONRY CHIMNEY MUST FIRST BE
INSPECTED BY A QUALIFIED CHIMNEY SWEEP OR INSTALLER.
NOTE: YOU WILL NEED A PIPE LENGTH EQUAL TO THE CHIMNEY HEIGHT FROM THE
HEARTH. IF OUTSIDE COMBUSTION AIR IS TO BE USED, YOU WILL NEED A PIPE LENGTH
EQUAL TO THE CHIMNEY HEIGHT PLUS 18 INCHES.
Eurostar Installation and Operation Manual
and following vent
flashing above the
21