Enerzone EUROSTAR Installation And Operation Manual page 50

FAILED IGNITION
TEMPERATURE HAS NOT
REACHED ITS START-UP
RESET
 Inadequate fuel is used. Remove the burn pot, make sure that all openings are clear and
check that no ash has filled the tube around the igniter. Refer to the maintenance section.
Also, make sure that recommended fuel is used (see Section 5.2.1 Proper Fuel).
 The igniter is defective. Go to the troubleshooting page (see Section 9.2 Testing
Components) and follow instructions for component check. Test the ignitor to see if it glows. It
should take no longer than two minutes. If it does not glow, check the wiring and the F3 fuse.
If the wiring is properly connected and the fuse is good, test the continuity of the igniter with a
multimeter.
 The flue temperature sensor failed. The "Thermistor" is a heat sensor located on the
exhaust motor housing. Its function is to tell the control board that the stove has ignited
properly by measuring the heat at the exhaust. When your stove is cold, check if the exhaust
blower temperature icon is showing cool
If after 10 minutes, the icon is still showing cool, the sensor is disconnected or defective. If the
icon changes and the temperature rise, you may have a problem on minimum feed rate or pilot
mode. Depending on many factors (ambient temperature, pellet quality, etc) the heat produced
by the stove may not be sufficient to keep the exhaust temperature high enough. To resolve
the situation increase feed rate, (see Section 6.1.6 Adjusting the Combustion Level (Heat
Output)).
THE IGNITER FUSE BLEW UP
RESET
 The igniter is defective: Test the continuity of the igniter with a multimeter. If it is good, the
ignitor is good. If it is defective, replace it and the F3 fuse.
 The wiring harness shorted. Inspect the wiring and replace any defective wire and or
connector. Make sure the wires are not shorted to the stove frame. Locate the fuse F3 on the
control board and replace it. Go to the troubleshooting page (see Section 9.2 Testing
Components) and follow instructions for component check. Test the ignitor to see if it glows. It
should take no longer than two minutes.
50
THE EXHAUST
VALUE AFTER TWO
IGNITION ATTEMPS
DETAILS
IGNITER FUSE
DETAILS
THE FOLLOWING MAY HAVE CAUSED YOUR
PROBLEM (FAILED IGNITION):
• INADEQUATE FUEL IS USED
• THE IGNITER IS DEFECTIVE
• THE FLUE TEMPERATURE SENSOR
FAILED
CONSULT OWNER'S MANUAL FOR
MORE DETAILS
BACK
COOL
. If yes, start the stove and monitor temperature.
THE FOLLOWING MAY HAVE CAUSED YOUR
PROBLEM (IGNITER FUSE):
• THE IGNITER IS DEFECTIVE
• THE WIRING HARNESS SHORTED
CONSULT OWNER'S MANUAL FOR
MORE DETAILS
BACK
Eurostar Installation and Operation Manual