Adjusting The Combustion Level (Heat Output) - Enerzone EUROSTAR Installation And Operation Manual

6.1.6 Adjusting the Combustion Level (Heat Output)

POSITION THE CURSOR TO SET THE
MIN
SAVE & EXIT
PILOT SETTINGS ADJUSTMENT
AUGER MOTOR 1
COMBUSTION FAN
EXHAUST FAN
BACK
The stove's input range goes from 8,500 BTU to 50,000 BTU. To change combustion level, select
the flame icon on the main status page to display the combustion level scroll bar. The scroll
bar is linearly scaled between the minimum and maximum.
Note: Input range may vary according to the type of pellets being used.
Even though your stove can burn a large variety of pellets, we strongly recommend the use of high
quality pellets to obtain maximum performance out of your stove (see Section 5.2.1 Proper Fuel).
When using lower quality combustible, a restrictive venting system or using the stove in high
altitude, you may need to adjust the "PILOT SETTING ADJUSTMENT" and the "FUEL QUALITY
ADJUSTMENT". These two (2) settings are available from the "COMBUSTION LEVEL" page.
Note: To obtain optimal results make sure the venting system, heat exchanger and exhaust
channels are cleaned before performing any setting changes.
6.1.6.1 PILOT ADJUST. (Pilot Settings Adjustment)
The "PILOT SETTINGS ADJUSTEMENT" will allow you to modify default settings by +/- 5% for
auger motor 1 and +/- 10% for exhaust fan, but will only apply during pilot cycle:
To restore default setting, select "DEFAULT".
Refer to following section for settings adjustments explanation.
30
COMBUSTION LEVEL
COMBUSTION LEVEL
MAX
PILOT FUEL Q.
ADJUST ADJUST
. .
+ - 0%
+ - -2%
+ - -5%
DEFAULT SAVE & EXIT
FUEL QUALITY ADJUSTMENT
AUGER MOTOR 1 + -
COMBUSTION FAN + -
EXHAUST FAN + -
BACK DEFAULT SAVE & EXIT
Eurostar Installation and Operation Manual
0%
0%
0%