Clearances To Combustible Material; Location Of The Certification Label; Minimum Clearances To Combustibles - Enerzone EUROSTAR Installation And Operation Manual

3 CLEARANCES TO COMBUSTIBLE MATERIAL

The clearances shown in this section have been determined by test according to procedures set
out in safety standards ULC S627 (Canada), ASTM E1509 (U.S.A). When the pellet stove is
installed so that its surfaces are at, or beyond, the minimum clearances specified, combustible
surfaces will not overheat under normal and even abnormal operating conditions.
WARNING: NO PART OF THE STOVE MAY BE LOCATED CLOSER TO COMBUSTIBLES
THAN THE MINIMUM CLEARANCES SPECIFIED ON THE CERTIFICATION LABEL.
CAUTION: NO PART OF THE PELLET VENT SYSTEM MAY BE LOCATED CLOSER TO
COMBUSTIBLES THAN THE MINIMUM CLEARANCES SPECIFIED BY THE VENT
MANUFACTURER.
CAUTION: DO NOT USE MAKESHIFT MATERIALS OR MAKE ANY COMPROMISES WHEN
INSTALLING THIS STOVE.

3.1 Location of the Certification Label

Since the information given on the certification label affixed to the stove always overrides the
information published in any other media (owner's manual, catalogues, flyers, magazines and/or
web sites), it is important to refer to it in order to have a safe and compliant installation. In addition,
you will find important information about your stove (model, serial number, etc.). You can find the
certification label on the inner side of the hopper lid of the stove.

3.2 Minimum Clearances to Combustibles

Note: We recommend leaving 24" on each side of the stove and 12" at the back of the stove
in order to facilitate access for maintenance.
* From the fresh air intake
Eurostar Installation and Operation Manual
CLEARANCES TO COMBUSTIBLES
LETTER
CANADA
A* 3" (76 mm)
B 4" (102 mm)
C 3" (76 mm)
Refer to vent
D manufacturer's
clearances
I 60" (1 525 mm)
USA
3" (76 mm)
4" (102 mm)
3" (76 mm)
Refer to vent
manufacturer's
clearances
60" (1 525 mm)
11