Removing And Installing Ribbed Belt (Poly V-Belt) Pulley On Alternator - Volkswagen Jetta 2005 Workshop Manual

– Position wiring bracket -arrow- on rear of generator at 9
o'clock.
– Tighten threaded connections to specified torque settings
⇒ page 145 .
Caution
Observe instructions on connecting battery terminals
⇒ page 4 .
– Connect the battery
– Start the engine and check belt running.
– Switch off the engine.
9.10.3 Ribbed belt routing, 2,0 l TDI engine
Models without air conditioning system:
1 - Tensioning roller
2 - Ribbed belt pulley - Alternator
3 - Poly V-belt
4 - Ribbed belt pulley - Crankshaft
Models with air conditioning system:
1 - Tensioning roller
2 - Ribbed belt pulley - Alternator
3 - Ribbed belt pulley - Air conditioner compressor
4 - Poly V-belt
5 - Ribbed belt pulley - Crankshaft
9.11 Removing and installing ribbed belt
(poly V-belt) pulley on alternator
9.11.1 Removing and installing a ribbed belt
(poly V-belt) pulley with no freewheel
Special tools and workshop equipment required
⇒ page 29 .
Jetta 2005 ➤ , Bora 2006 ➤
Electrical System - Edition 05.2005
137
9. Alternator