Volkswagen Jetta 2005 Workshop Manual page 122

Jetta 2005 ➤ , Bora 2006 ➤
Electrical System - Edition 05.2005
– Drive threaded sleeves -A- out of the alternator housing for
approx. 4 mm in -direction of arrow-.
– Position wiring bracket -arrow- on rear of generator at 12
o'clock.
– Tighten threaded connections to specified torque settings
⇒ page 145 .
Caution
♦ When reinstalling used ribbed belts (poly V-belts) observe
the direction of rotation marked on removal!
♦ Ensure, before installing ribbed belt, that all ancillaries (al‐
ternator, air conditioner compressor) are secured tightly.
♦ Ensure ribbed belt (poly V-belt) is seated correctly in belt
pulley when installing.
– Tighten threaded connections to specified torque settings
⇒ page 145 .
Caution
Observe instructions on connecting battery terminals
⇒ page 4 .
– Connect the battery
– Start the engine and check belt running.
– Switch off the engine.
9.6.3 Ribbed belt routing, 2,0 l FSI engine
Models without air conditioning system:
1 - Tensioning roller
2 - Ribbed belt pulley - Alternator
3 - Poly V-belt
4 - Ribbed belt pulley - Crankshaft
114
Rep. Gr.27 - Starter, current supply, CC
⇒ page 29 .