Volkswagen Jetta 2005 Workshop Manual page 185

Note
Repair points must not be subjected to pulling or bending
♦
forces.
If the damaged section is longer than 20 mm, a new piece of
♦
corrugated pipe must be used and the procedure described
below must be performed twice.
– Cut damaged section at right angles out of corrugated pipe
which is to be repaired.
– Select the appropriate connectors -2- and -3- as well as the
appropriate heat-shrink hose according to the parts catalogue
(ETKA).
– Heat end of corrugated pipe -1-.
– Push connector -2- into corrugated pipe -2- -arrow A-.
– Heat end of corrugated pipe -4-.
– Push connector -3- into corrugated pipe -4- -arrow B-.
– Cut heat-shrink hose so that ends of corrugated pipe are each
covered by about 20 mm -dimension x- of heat-shrink hose.
– Push heat-shrink hose over corrugated pipe, join connectors
and secure repair joints with heat-shrink hose.
Jetta 2005 ➤ , Bora 2006 ➤
Electrical System - Edition 05.2005
177
5. Hose repair