Cleaning And Maintaining The Printer; Preventative Maintenance; Cleaning The Print Cartridges; Cleaning The Photo Sensor Assembly - Bryce 30K User Manual

Addressing printer

Table of Contents

The 30K Printer is designed for trouble free service with a

minimal amount of care. Periodic cleaning of the Sensor,

Transport Belts, Floor and 3 Print Head Assemblies will be

necessary.

CLEAN PRINT CARTRIDGE, INK SURFACES AND COVERS WITH PLAIN WATER.

ALL METAL AND PLASTIC CAN BE CLEANED WITH ISOPROPYL, DENATURED & RUBBING

ALCOHOL OR WATER ONLY.

USING ANY OTHER CLEANING SOLVENTS WILL VOID ALL WARRANTIES.

Keep cleaning solvents with petroleum based products from rubber or plastic parts.

If the print quality is unacceptable select the Purge Print Head

function from the Main Menu (See Section Purge Print Head).

If problems still persist then do the following:

•

Remove the Print Cartridge (See Section

Remove Print Cartridges). Clean the nozzles

with a soft cotton cloth. Use a dry cloth

or one moistened with alcohol to clean

the ink jet cartridge.

•

Remove problem print cartridge and

install a new print cartridge.

Perform a self cleaning (Purge Print Head) cycle at the

start before printing and periodically while printing to

keep the nozzles clear of dry ink and debris.

With use, a film and/or dust builds up on the eye of the sensor

causing misfeeds of media. Periodically use compressed air to

blow dust from the sensors. For caked on dust use a Q-tip to

remove the dust from the eye of the sensor. Note: The lower

half of the Sensor is

seen through the hole

in the floor.

Revision C