Preparing The Media - Bryce 9K-L User Manual

Preparing
the Media
Note
: Maximum
thickness is 1/9" for
the 9KL.
Revision A
Recheck that all the necessary components of the printer are
installed.
• Is the Wire Form Assembly installed?
• Is the Sliding Fence installed?
• Is the printer plugged into a power outlet?
• Does the printer have an Ink Jet Cartridge installed?
• Is the printer connected to the computer?
Now that all the parts of the printer are installed the printer
needs to be adjusted to work with the media. To avoid
problems of misfeeding and jams the media must also be made
ready for the printer.
Use the following steps to make the media ready for printing:
1. Take a manageable pile of media and while holding
them (as shown below in reference A), "fan" all sides
of the media to make sure that each piece of media is
free from one another.
2. Square the pile against the table top, assuring a square
pile on all sides. (Reference B) This will also allow
media to settle toward the bottom of a stuffed envelope
and will increase the feeding capabilities of the printer.
Fan All Sides of Media
9K-L USERS MANUAL
P/N 90-00860-001
Operating the Printer
Square Media
Section 4 -
5