Fireplace Insert Setup; Glass Assembly - kozy heat CSK-34-R Installation And Operation Manual

9.0 FIREPLACE INSERT SETUP

9.1 Glass Assembly

WARNING: Do not operate this fireplace with the glass removed,
cracked, or broken. Replacement of the glass assembly, #701-
001T, should be done by a licensed or qualified service person.
9.1.1 Remove Glass Assembly
WARNING: Do not remove the glass assembly when hot.
1. Locate (2) spring-loaded latches securing the glass assembly
at the bottom of the firebox.
2. Pull the spring-loaded latches out and down to release the
bottom of the glass assembly.
3. Lift glass assembly up and off of the (2) tabs located at the
top of the firebox.
9.1.2 Install Glass Assembly
1. Align the slots on top of the glass assembly over the tabs at
the top of the firebox while lowering the bottom of the glass
assembly into position.
2. Pull the spring-loaded latches out and up to secure the
bottom of glass to the bottom of the fireplace.
SPRING-LOADED LATCHES
Figure 9.1, Glass Assembly
20 FIREPLACE INSERT SETUP
TABS