Remote Control Installation - Valor 530XAN Installation And Owner's Manual

12.0 REMOTE CONTROL INSTALLATION

Caution! Don't connect the batteries to the remote control receiver until the wires are
connected to the burner control unit, as short circuit could result in destruction of the
electrical components.
When installing the remote please refer to figures 57 and 58 below.
•
Connect the wiring harness to the receiver box, by pushing the wire connector on to the receiver circuit
board. The plug will only go on one way so please ensure that the wires are pointing up and slot in the
board is inline with the tab on the wiring harness plug ( see fig 58 )
•
Connect wires as shown in Fig 58. Please
note that the "L" connectors are different
sizes, the smaller one fits to the lower
connection on the valve.The other wire
connectors can be fitted to either terminal
.
•
Remove the remote control receiver lid.
•
Fit four 1.5V batteries.
•
Place the remote control receiver on the
"Velcro" pad.
•
Fit the 9V battery to the handset
transmitter
Remote control operating instructions are on
page 44 of this manual and are supplied with
the remote control kit.
Figure 58
Figure 57 Valve connections
35 of 50