Lighting Instructions - Valor 530XAN Installation And Owner's Manual

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage,
personal injury or loss of life.
A.This appliance has a pilot which must be lighted by hand. When lighting , follow these instructions exactly. To save
energy, turn the pilot off when not using the appliance.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor. WHAT TO DO IF YOU SMELL GAS:
-Do not try to light any appliance.
-Do not touch any electric switch; do not use any phone in your building.
-Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. If you cannot
reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the control knobs. Never use tools. If the controls will not push in or turn by
hand, don't try to repair them, call a qualified service technician. Force or attempted repair may result in a fire or
explosion.
D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control system and any gas control which has been under
water.
1. STOP! Read the safety information above
2. Set the thermostat as far clockwise
3. Turn the gas control knob clockwise to OFF.
NOTE: The knob cannot be turned from PILOT to OFF unless it is
pushed in partially. Do not force.
4. Wait five (5) minutes to clear out any gas. then smell for gas, including near the floor. If you smell gas, STOP!
Follow "B" in the safety information above. If you don't smell gas, go to the next step.
5. Find the pilot. It is at the left side.
6. Push in and turn the gas control knob counterclockwise until resistance is felt just before the "IGN" position.
7.
Keep pushed in for a few seconds to allow gas to flow then, keeping knob depressed, turn to "PILOT" to light
pilot. Hold knob in for a further 10 seconds then release. The knob should pop back out. Pilot should remain lit. If
pilot goes out repeat steps 3 through 7. If knob does not pop out when released, stop and immediately call your
service technician or gas supplier; If pilot lights but will not stay lit after several tries, turn the gas control knob
to "OFF" and call your service technician or gas supplier.
8. When pilot is lit, partially depress the knob and turn to "ON" position (Burner alight). Do not leave knob set
between "PILOT" and "ON".
9. Set thermostat to desired setting*.
1. Set the thermostat as far clockwise as possible*
2. Push in gas control knobb slightly and turn clockwise to "OFF". Do not force.
*The flame height can be increased or decreased by depressing the remote control
hand set button.

20. LIGHTING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING
LIGHTING INSTRUCTIONS
as possible*.
TO TURN OFF GAS TO APPLIANCE
49 of 50