Table of Contents
Advertisement
Caution! Don't connect the batteries to the remote control receiver until the wires are
connected to the burner control unit, as short circuit could result in destruction of the
electrical components.
When installing the remote please refer to figures 57 and 58 below.
•
Connect the wiring harness to the receiver box, by pushing the wire connector on to the receiver circuit
board. The plug will only go on one way so please ensure that the wires are pointing up and slot in the
board is inline with the tab on the wiring harness plug
•
Connect wires "A" (with the "L" terminals)
to the connectors "B" on the control valve
Please note that the connectors are
different sizes, the smaller one fits to the
lower connection on the valve.
•
Connect the wires "C" to the connectors
"D" on the control valve. (Either wire can
be fitted to either connector).
•
Remove the remote control receiver lid.
•
Fit four 1.5V batteries.
•
Place the remote control receiver on the
"Velcro" pad.
•
Fit the 9V battery to the handset
transmitter
Remote control operating instructions are on
page 41 of this manual and are supplied with
the remote control kit.
Figure 58
11. REMOTE CONTROL INSTALLATION
"D"
"B"
Figure 57 Valve connections
"A"
"C"
33
Advertisement
Table of Contents
