Valor 530XAN Installation And Owner's Manual page 43

4. Install plinth and rear support channel below firebox (optional)
The purpose of the plinth is to allow the appliance to be placed on a
rough subfloor, such as plywood, without regard for the additional
thickness of tile etc. as the appliance bottom must otherwise be placed
at the finished hearth height or the front trims will not fit on the
appliance properly.
Detach the burner module by removing 11 screws. See figure 88.
Fit the rear support channel under the rear of the appliance attaching it
to the appliance back panel with two
screws – see figure 91.
Fit the front plinth under the appliance front with two thread forming
screws – See figure 89.
5. Install Top Insulation layers.
For top vent outlet appliances cut out a circle at the center of the
insulation layers for the vent collar.
Place both the insulation layers on top of the appliance case inboard of
the standoff spacers. See figure 90.
Warning: Failure to install both the insulation layers may cause a
fire hazard and voids warranty.
6. Hang the Front Casting on the appliance by the hooks at the top
corners – Hooks may be shipped loose and require mounting to the
casting. (See figure 92).
Fig. 90
Figure 92
3 /
" thread cutting (pointed end)
8
43 of 50
Fig. 88
Fig. 89
Fig 91