Valor 530XAN Installation And Owner's Manual page 45

3. Locate Side Mounting Brackets as shown in fig. 96
and line up the mounting holes in the side of the heater
body (note either channel may be fitted to either side).
Secure the side channels to the heater using the screws
provided – 2 per side.
4. Locate Top Insulation Blanket.
For top vent outlet appliances, cut out a circle at the center
of the insulation layers for the vent collar.
Place both the insulation layers on top of the appliance
case inboard of the stand-off spacers. See figure 97.
!Warning: Failure to install both the insulation layers may
cause a fire hazard and voids warranty.
5. Secure the Outer Cast Arch to the Appliance as shown
with self tapping screws provided. See figure 99.
Tighten screws enough to ensure a tight fit between casting
and sheet metal parts.
(it may be necessary to re-drill 1/8" pilot holes for the self
tapping screws due to miss alignment caused be shifting
tolerances with the cast iron arch.)
Note – The weight of the Cast Iron Surround must not
be carried by the connection to the heater – it must sit
on a hearth or be securely screwed to the wall.
6. Hang the Inner Cast Arch on the Outer Arch by inserting
the mounting hooks into the notches in the Outer Arch, see
Figure 98. The fit or Gap between the Inner Cast Arch and
the Outer Cast Arch, may be tightened by bending the
mounting hooks slightly inwards. Do Not Bend The
Hooks Too Far or The Removable Inner Arch Will Be
Difficult to Remove! If this happens a screwdriver
inserted through the gap between the back of the casting
and the heater should be able to pry the hook away of the casting. Do not impact the hooks with a hammer as this
may break the welds holding the hooks.
Slide the Hearth Fender up to the front of the casting as shown in Figure 98. Note – it is important that the
hearth in front is flush with the bottom of the heater, otherwise the Hearth Fender will not rest at the proper
height.
Fig 98 , Hang Inner Cast Arch to Outer Arch.
Fig. 96,
Fig 97, Insulation Blanket.
Fig 99, Secure outer Cast Arch to Heater.
45 of 50