Cleaning - Valor 530XAN Installation And Owner's Manual

19.3 Cleaning

1. It will be necessary to clean the glass periodically. During startup,
condensation, which is normal, forms on the inside of the glass and causes dust,
lint etc. to cling to the glass surface. Initially paint, while curing, may deposit a
slight film on the glass. We therefore recommend that, during the first few
weeks of use, the glass is cleaned two or three times with non-abrasive common
household cleaners and warm water. Ammonia based cleaners should not be
used. Subsequently the glass should be cleaned two or three times a season
depending on the circumstances. Do not clean the glass while it is hot.
2. Dust, etc. can be brushed from the ceramic fuel effects and firebox walls
after removing the front unit and opening the window.
Removing the front unit
•
President FS: Remove top & unhook front unit – See figure 100
•
President/Bolero ZC: Unhook the front unit. Lift the front by holding the
decorative grille. Don't lift by holding the top. See figure 101
•
Windsor Arch. Pull away the ashguard at the bottom and unhook the Inner
Cast Arch as shown in Fig. 102.
Opening the window (See figure 103)
Always securely replace the window before lighting.
The inside of the window can be cleaned by pulling forward and rotating the
two clamping bars at the top corners of the window and swinging the window
part way down. ! Be careful not to distort or damage the spring-loaded bolts
– Don't swing the window down more than is necessary!
To completely remove the window, also unscrew the two springs
loaded bolts at the bottom of the window. After refitting the
window apply light hand pressure against the window frame sides
to bed in the window seal.
Dust etc. can also be removed from the burner using a soft brush after
removing the ceramic fuel effects. Always completely remove the
window before removing the ceramic fuel effects.
When cleaning, make sure that no particles are brushed into the slots
in the burner.
Fig. 102
Fig.100
Fig.101
Fig.103
47 of 50