President 536/Bolero 541 Z.c Fronts - Valor 530XAN Installation And Owner's Manual

18.2 PRESIDENT 536 / BOLERO 541 Z.C FRONTS
18.2.1 536/541 Kit Contents
Kits are identical other than items marked " 536 or
541" which are specific to each version.
1 Front Casting ( 536 or 541 version)
1 Top air deflector ( 536 or 541 version)
2 Stand-off spacers (Supplied flat)
2 Top insulation layers
1 Framing Plate w/ Brackets (536 or 541
version)
1 Front plinth
1 Rear base support channel
1 Pack of thread cutting screws
2 Hooks For hanging the front ( 536 or 541
version)
18.2.2 536/541 Kit Installation
1. Fit the top air deflector under the top
panel of the appliance case. Secure with two thread forming screws. See
figure 85.
2. Fit the Stand-off Spacers.
The standoff spacers for these installations are supplied flat. These spacers
are left and right handed.
! Warning: Failure to install the standoff spacers may result in a fire
hazard.
Remove the two screws near each of the rear top corners of the appliance
and the two screws near the rear top of each side.
Bend the spacers as shown in figure 86.
Screw the spacers to the rear of the appliance using the screws just
removed. See figure 86.
Bend the side wings of the spacers to align the two holes in each spacer with those
in the appliance sides. Secure the spacers using the screws just removed. See figure
86.
3. Mount the Framing Plate to the appliance.
Secure the Framing Plate and Brackets to the sides of the appliance case with four
thread cutting screws supplied. Screw from the outside through the access holes in
the Framing Plate.– See figure 87.
Note – There are alternate methods of finishing around the Framing Plate –
either leaving it exposed or
recessing it and covering it up
with the wall finish – See
Section 5.3.
Fig 84, 536/541 Components
Fig. 86
42 of 50
Fig.85
Fig. 87