4.3.3 Setting media type
Introduction:
Be sure to read and understand the safety warnings before handling the printer.
When you have loaded the media in the ValueJet, you will have to set the media type. The Media setup
menu is displayed after the media hold lever is pushed from the backward position to the forward position. (=
lever down)
Notes
The printer starts the media initialization without setting the media type when
•
The [Cancel] key of the operation panel is pressed.
•
No key operations are performed on the operation panel for 10 seconds.
Procedure:
Step 1 :
Verify that the printer has been switched ON, and the media has been loaded.
Result: After the media is loaded, the display shifts to the Media setup menu.
Notes
Refer to the following topics to load media:
•
Installing roll media
•
Loading roll media
No.
Name
1
Media hold lever
58
User's Guide ValueJet 1604
Chapter 4: Handling the printer
1
AP-75760 – Rev 1.1 -21/06/2007,