MUTOH ValueJet VJ-1604 User Manual page 87

4.7.1.11 Dryer menu
Notes
•
Temperature to be set for the after Heater varies depending on the media which is used. For
recommended temperature settings of the after heater, refer to the "Recommended media list".
Setup Item
After Heater
4.7.1.12 Standby Heating menu
Set up whether each heater is preheated (idle heat) while in standby mode.
Setup Item
StandbyHeating
4.7.1.13 Vacuum Fan menu
Setup Item
Vacuum Fan
Setting Value
OFF / <30° C> to 50° C
—
Setting Value
OFF Idle heat is not performed.
<ON> Set up whether each heater is preheated while in standby mode.
•
•
—
Setting Value
Low Set when using soft media
<High> Set when regular media is used.
•
•
—
Set up the after Heater temperature.
2
1. Roll media
2. Dryer- After heater
3. Print head
•
[Enter] key: Save the setting and shift to the
previous hierarchy.
•
[Cancel] key: Cancel the setting and shift to
the previous hierarchy.
► User media menu
Description
[Enter] key: Save the setting and shift to the previous
hierarchy.
[Cancel] key: Cancel the setting and shift to the previous
hierarchy.
► User media menu
Description
[Enter] key: Save the setting and shift to the previous
hierarchy.
[Cancel] key: Cancel the setting and shift to the previous
hierarchy.
► User media menu
87
User's Guide ValueJet 1604
Chapter 4: Handling the printer
Description
3
AP-75760 – Rev 1.1 -21/06/2007,
1