MUTOH ValueJet VJ-1604 User Manual page 138

6.3.4 Printing-related troubleshooting
Printing is partially stained or incomplete.
Notes
•
Proper print quality may not be obtained with the media other than the recommended one.
Possible cause
No.
Does the media
1
include moisture?
Are you using the
2 folded or wrinkled
media?
Does the media
3 bend?
The printing position is incorrect (some parts of the media cannot be printed on)
No. Possible cause
Is the loading position
1
of the media correct?
Did you set up the
origin and print
2
position?
Printing is blurred
No. Possible cause
Are you using the
1 recommended
media?
Are you using thick
2
or thin media?
Is the media printed
3 on the printing
surface?
Did you perform an
4
Alignment?
Did you perform a
5 Media feed
compensation?
Is each heater set to
6 the appropriate
temperature?
Is the head height
7
set to High?
Remedy
Replace it with new media.
Use the recommended media. When using
media other than the dedicated one, set the
Vacuum Fan menu.
Set the media correctly.
Cancel or reset the settings of the origin and print
position.
Use the recommended media.
Use the recommended media.
Confirm the printing surface of the media and set it
correctly.
Perform Alignment.
Perform Media feed compensation.
Set it to the appropriate temperature.
Return the head height to "Normal (Low)".
138
Remedy
Remedy
AP-75760 – Rev 1.1 -21/06/2007,
User's Guide ValueJet 1604
Chapter 6 : Troubleshooting
Reference
"Replacing roll media"
" "Panel setup menu"
Reference
Setting roll media
"Panel setup menu"
Reference
Setting media
Adjust the print
head
"Media feed
compensation"
"Panel setup menu"
"Head height
adjustment"