MUTOH ValueJet VJ-1604 User Manual page 135

Does not work after loading the media.
No. Possible cause
Is the front cover open or media loading lever
1
raised?
2 Is the maintenance cover open?
3 Is the media loaded at an angel?
4 Is the ink cassette inserted?
5 Are you using he recommended media?
Is the printer being used in an environment
6
other than the one specified?
When data is sent from the computer, an error occurs at the printer and nothing is printed
No. Possible cause
Is the type of printer selected correctly at the
1
computer
Are the interface requirements and command
2 mode the same on the computer side as on
the printer side?
Cannot use the computer online using LAN
No. Possible cause
Is the network interface cable connected
1
correctly?
2 Are the network settings configured correctly?
Match the printer's network settings with the
3
computer side environment.
Does the data lamp on the operation panel
4
switch ON after sending printing data from the
computer?
Be sure to read and understand the safety warnings before handling the printer.
remedy
Close the front cover.
Lower the media loading
lever.
Close the maintenance
cover?
Load the media straight
Insert the ink cassette
Use the recommended
media
Only use the printer in an
environment that is
specified for use.
remedy
Check that the printer
type settings on the
computer side and on
the printer side are the
same.
remedy
Confirm the types of the
cross and straight
cables, and connect the
network interface cable
correctly
Configure the network
settings correctly
Match this product's
network settings with the
computer side
environment
If the data lamp does not
switch ON, contact the
computer manufacturer
135 AP-75760 – Rev 1.1 -21/06/2007,
User's Guide ValueJet 1604
Chapter 6 : Troubleshooting
Reference
"setting media"
"cleaning the wiper"
"Setting media"
"install ink cassettes"
"installation manual"
Reference
"connecting the printer to
a PC"
Reference
"connecting a network
interface"
"panel setup menu"
"system requirements"