MUTOH ValueJet VJ-1604 User Manual page 54

Step 5 : Pull the roll media out about 1m from the front media feed slot which is located inside of the front
cover.
Step 6 : Rewind the roll media a little by rolling the flange on the roll media holder while holding the edge
of the media, eliminate any slack or slant.
Notes
•
If you set the roll media free while rewinding, the roll media will fall out from the media feed slot on the
rear of the product.
•
Confirm that the right edge of the roll media does not go beyond the loading mark. If it does, it may
affect print quality.
Notes
•
When setting the roll media, set both sides of the media at least 5mm away from the edge of the
pressure roller. Slippage or creases may occur during printing.
No. Name
1 Roll media
2 Media feed slot
No. Name
1 Roll media
2 Media loading mark
54
User's Guide ValueJet 1604
Chapter 4: Handling the printer
2
1
AP-75760 – Rev 1.1 -21/06/2007,