Take the same procedure as in step 4, remove the roll media from the left roll media holder.
Step 5 :
1
3
To load another roll media, refer to: "Setting media"
Notes
•
To load another roll media, refer to: " Setting media"
•
Store the roll media you do not use according to: Notes on storing media
•
Attach the movable flange to the scroller when you do not set roll media, this to set the scroller to the
printer.
3.5.3 Setting media type
Introduction:
When you have loaded the media in the ValueJet, you will have to set the media type. The Media setup
menu is displayed after the media hold lever is pushed from the backward position to the forward position. (=
lever down)
Notes
The printer starts the media initialization without setting the media type when
•
The [Cancel] key of the operation panel is pressed.
•
No key operations are performed on the operation panel for 10 seconds.
2
1
3
Nr.
1
Roll media holder (left)
2
Fixing lever
3
Roll media
name
38
Operation Instructions VJ-1604
AP-75769 - Revision 1.0 –2/04/2007
English