MUTOH ValueJet VJ-1604 User Manual page 34

Result: The operation panel displays "Ink Refill **%", and the initial ink replenishment starts.
•
The ink replenishment takes about five minutes. Initial ink replenishment and pause operation are
repeated during initial filling.
•
When "100%" is displayed, the ink replenishment is complete.
•
After the first ink fill, the displays shows "Subtank Refill"
•
The operation panel displays "Subtank Refill **%",
•
It takes about 5 min to refill the subtank.
•
After the ink replenishment the operation panel displays "Media End"
Notes
During ink filling :
•
Do NOT switch OFF the printer.
•
Do NOT pull out the printer power cables.
•
Do NOT open the front cover.
•
Do NOT push the media hold lever to the back side.
Notes
•
After an initial ink fill, the following can occur :
Printed lines become blurred.
o
White lines appear in the prints.
o
•
If this is the case, perform a head cleaning, two to three times, as shown in the chapter "Head
cleaning", and check the results.
•
If the quality of the printed image has not improved, even after performing head cleaning, then leave
the printer unused for more than one hour. After that, perform another head cleaning and check the
printed image. If the quality still has not improved, contact your local MUTOH dealer.
Notes
•
Only use Mutoh original ink for ValueJet printers.
This printer has been adjusted for use of genuine ink cassettes. In case of using non genuine ink
cassettes, notice the following :
Printing might become blurred and the end of ink in the cassette might no longer be correctly
o
detected.
The problems caused by the use of non original ink cassettes will not be covered by the warranty
o
and repair costs will be at the expense the customer.
•
When ink cassettes are moved from a cold place to a warm place, keep the ink cassettes unused for
three hours or more in the printing environment.
Be sure to read and understand the safety warnings before handling the printer.
34 AP-75760 – Rev 1.1 -21/06/2007,
User's Guide ValueJet 1604
Chapter 3 : Installing the Unit