Switching The Power Off - MUTOH ValueJet VJ-1604 User Manual

3.4.2 Switching the power OFF

Be sure to read and understand the safety warnings before handling the printer.
Step 1 : Before powering OFF, be sure that:
•
Printing or other operations are stopped or finished.
•
The printer (and operation panel) is in normal mode.
•
The head height adjustment lever is lowered
Step 2 : Press the [Power] key on the operation panel to switch OFF the printer.
•
The Power indicating light on the operation panel switches OFF.
Notes
•
If the [POWER] key is pressed or the power indication light lights up green, the power is ON.
•
Press the key once again and switch OFF the power.
•
"Power OFF" is displayed on the operation panel.
Notes
•
If the head height adjustment lever is raised, "Change Head Gap Low" is displayed. Lower the lever.
•
All the indication lights on the operation panel and the LCD monitor are switched OFF.
•
The printer automatically switches the power OFF.
Notes
•
If there is a problem during the Power OFF sequence, the printer displays a message on the operation
panel and may stop operating.
In the case operation stops, refer to "Troubleshooting".
•
After switching OFF the printer, wait for 10 seconds or longer to switch it ON again.
Step 3 : Raise the media hold lever after the powering OFF cycle, so you will not damage the media by
the pressure of the grid rollers.
No. Name
1 Head height adjustment lever
31
User's Guide ValueJet 1604
Chapter 3 : Installing the Unit
AP-75760 – Rev 1.1 -21/06/2007,