Transporting The Printer - MUTOH ValueJet VJ-1604 User Manual

3.8.2 Transporting the printer

Be sure to read and understand the safety warnings before handling the printer.
When transporting the printer, it is necessary to pack the printer as it was shipped, using the protective
materials and packing materials to protect the printer from vibration and shocks.
Notes
•
When transporting the printer, consult your MUTOH product dealer.
(1) Pre- transport procedure
Step 1 : Switch ON the printer.
Step 2 : Verify that the printer is in Normal mode.
Step 3 : Remove all ink cassettes.
Step 4 : Switch OFF the printer.
• Result: The operation panel displays "Transport Mode", and the printer starts the ink rejecting
operation.
• The ink rejecting operation takes about 2 minutes.
Step 5 : Verify that the power light faints when the ink rejection operations has been finished.
Step 6 : Remove the scroller or the optional winding system.
Step 7 : Remove all cables.
Step 8 : Attach the protective material (metal plate) to the head unit, and fix it with thumbscrews.
Step 9 : Remove the printer from the stand. Refer to: "Installation guide"
Step 10 : Repack the printer.
(2) Post-transport procedure
Step 1 : To perform unpacking, assembling, and placing the printer. Please refer to: "Installation guide"
Set the printer in an available condition. Please refer to "Transferring the printer" and "Steps after
transfer"
No.
1 Head unit
2 Butterfly screw
3 Head unit fastening material (metal plate)
41
Name
AP-75760 – Rev 1.1 -21/06/2007,
User's Guide ValueJet 1604
Chapter 3 : Installing the Unit