Setting Srm Environment Variables - HP AlphaServer TS15 Owner's Manual

2.5

Setting SRM Environment Variables

You may need to set several SRM console environment variables and built-in utilities
to configure the system.
You can set environment variables at the >>> prompt.
•
To check the setting for a specific environment variable, enter the show envar
command, where the name of the environment variable is substituted for envar. To see
a list of the environment variables, enter the show * command. For example, to display
the default boot device, use show bootdef_dev.
•
To reset an environment variable, use the set envar command, where the name of the
environment variable is substituted for envar. For example, to set the default boot
device to , use set bootdef_dev dkb0.
dkb0
•
To turn off console security for the current console session, use the login command.
The environment variables used to set up the boot environment are described in Chapter 3.
Chapter 5 covers other environment variables you are likely to use.
2-16 hp AlphaServer TS15 Owner's Guide