HP AlphaServer TS15 Owner's Manual page 76

Adaptec AIC-7899 Adapter: H/W Rev 0, Driver Rev 2.274 CHIM V364A3
scsi1 at aha_chim2 slot 0 rad 0
ee0 at pci0 slot 9
ee0: COMPAQ Intel 82559ER (10/100 Mbps) Ethernet Interface
ee0: Driver Rev = V1.0.21, Chip Rev = 9, hardware address: 00-02-A5-20-C0-39
ee1 at pci0 slot 10
ee1: COMPAQ Intel 82559ER (10/100 Mbps) Ethernet Interface
ee1: Driver Rev = V1.0.21, Chip Rev = 9, hardware address: 00-02-A5-20-C0-3A
ata0 at pci0 slot 13
ata0: ACER M1543C
scsi2 at ata0 slot 0 rad 0
ee0: Autonegotiated, 100 Mbps full duplex
ee1: Autonegotiated, 100 Mbps half duplex
scsi3 at ata0 slot 1 rad 0
pci2 (primary bus:2) at nexus
vga0 at pci2 slot 7
640x480 VGA, 16 colors
vga0: generic VGA driver
Created FRU table binary error log packet
kernel console: ace0
dli: configured
NetRAIN configured.
Random number generator configured.
vm_swap_init: swap is set to lazy (over commitment) mode
INIT: SINGLE-USER MODE
#
Explanation
Perform the following tasks to boot a Tru64 UNIX system:
1. Power up the system. The system stops at the SRM console prompt, >>>.
2. Set boot environment variables, if desired. See the beginning of this chapter.
3. Install the boot medium. For a network boot, see Section 3.2.1.
4. Enter the show device command to find the unit number of the drive for your device.
5. Enter the boot command and command-line parameters (if you have not set the
associated environment variables). In the preceding example, boot flags have already
been set.
3-12 hp AlphaServer TS15 Owner's Guide