Set Escape; Set Password - HP AlphaServer TS15 Owner's Manual

set escape

The set escape command sets a new escape sequence for invoking the RMC. The escape
sequence can be any string, but cannot exceed 14 characters. A typical escape sequence
includes two or more control characters.
set init
The set init command sets the modem initialization string. The string is limited to 31
characters and is converted to uppercase.
set logout
The set logout command sets the amount of time before the RMC terminates an inactive
modem connection. The default is 20 minutes.
The settings are in tens of minutes (0-9). The zero (0) setting disables logout. When logout
is disabled, the RMC never disconnects an idle modem session.

set password

The set password command lets you set or change the password requested at the beginning
of a modem session. You must set a password to enable access through a modem. The
string cannot exceed 14 characters and is not echoed to the screen.
set user
The set user command allows the user to set a user string to be displayed by the status
command. This string is typically used to make notes about the current status of the system.
The string is limited to 63 characters.
status
The status command displays information about the current status of the system and its
RMC settings. (See section 6.6.1.)
6-44 hp AlphaServer TS15 Owner's Guide