HP AlphaServer TS15 Owner's Manual page 117

1. Shut down the system and remove the top cover as explained in Section 4.2.
2. Remove the slot cover screw
enclosure.
3. Slide the PCI option module
riser .
4. Insert the screw
5. Replace the top cover and reassemble the system enclosure as explained at the end of
Section 4.2.
6. Turn on system power by pressing the power switch on the operator control panel. Boot
the operating system.
Verification
1. Turn on power to the system.
2. At the >>> prompt, enter the SRM show config command. Examine the PCI bus
information in the display to make sure that the new option is listed.
3. If you installed a bootable device, enter the SRM show device command to determine
the device name.
See Chapter 1, the section on PCI Slots, for more information about PCI slots.
; remove the slot cover
into the first available slot and plug it into the PCI
to secure the module.
Installing and Configuring Options
by sliding it out of the
4-31