Powering Up The System; Figure 2-1 Leds On The Operator Control Panel - HP AlphaServer TS15 Owner's Manual

2.1

Powering Up the System

To power up the system, press the power button. Testing begins, and system status
shows on the console terminal screen and at the operator control panel (OCP) display.
Figure 2–1 LEDs on the Operator Control Panel
1
Halt/Reset button
Amber system fault LED
Amber over temperature fault LED
Amber fan fault LED
Green disk activity LED
Green system power LED
System Power Switch (On/Off)
NOTE: The power button must be in the On position for the RMC power commands
to function.
To control power to the system remotely, use the RMC power off and power on commands.
RMC> power off
RMC> power on
2-2 hp AlphaServer TS15 Owner's Guide
2 3 4 5 6 7
MR0621