HP AlphaServer TS15 Owner's Manual page 119

Installing an ATI Radeon Graphics Card
1. Shut down the system and remove the top cover as explained in Section 4.2.
2. If there is no module in PCI slot 1, refer to Figure 4–18. Remove the PCI slot cover
screw , then remove the slot cover
3. If there is a module in slot 1, move it to the next available slot as explained in the
preceding procedure.
4. Referring to Figure 4–19, slide the Radeon card
the PCI riser .
5. Carefully slide the support bracket
Radeon card.
CAUTION: Notice that the lower bracket
two screws
of the Radeon card.
6. Fasten the support bracket to the right edge of the PCI riser using the two screws
provided.
7. Push up the lower bracket
the Radeon card.
8. Insert the slot screw
9. Replace the top cover and reassemble the system enclosure as explained at the end of
Section 4.2.
10. Turn on system power by pressing the power switch on the operator control panel. Boot
the operating system.
by sliding it out of the enclosure.
onto the right edge of the PCI riser and the
is loosely fastened to the support bracket by
. Be careful not to damage any components near the right edge
and tighten the two screws
to secure the connector end of the card.
Installing and Configuring Options
into slot 1 as shown and seat it into
to secure the right edge of
4-33