HP AlphaServer TS15 Owner's Manual page 105

Replacing Bottom Drive – Internal Storage Cage
1. Shut down the system and remove the top cover as explained in Section 4.2.
2. Remove the internal storage cage and all cables as explained in Section 4.8.
3. Remove the four screws
from the cage.
4. Slide the new drive into the cage and insert the four screws.
5. Reinstall the storage cage as explained in Section 4.8.
6. Replace the top cover and reassemble the system enclosure as explained in the end of
Section 4.2.
7. Turn on system power by pressing the power switch on the operator control panel. Boot
the operating system.
Verification
Enter the SRM and use the init and show device commands to verify that the system has
identified the new drive.
from the sides of the bottom drive
Installing and Configuring Options
and slide the drive
4-19