Configuring Remote Dial-In; Example 6-1 Dial-In Configuration - HP AlphaServer TS15 Owner's Manual

6.7

Configuring Remote Dial-In

Before you can dial in through the RMC modem port or enable the system to call out
in response to system alerts, you must configure RMC for remote dial-in.
You can use either a VT terminal or a VGA monitor to configure the RMC for remote dial-
in:
1. Connect to the RMC using either a VT terminal attached to COM1 or through the VGA
monitor. See Figure 6–3 or Figure 6–4 for connections.
2. Initialize the remote dial-in configuration as shown in Example 6–1.
3. Complete one of the following:
a. If you use a VT terminal, disconnect it and connect the modem to COM1.
b. If you are using a VGA monitor, connect the modem to COM1.
NOTE: When configuring the system for dial-in access, com1_mode must be set so that
you are able to gain access to the RMC via either the VT terminal on COM1 or
the VGA monitor.
Example 6–1 Dial-In Configuration
RMC>>> set password
RMC Password: *****
Verification: *****
RMC> set init
Init String: at&h2e0&c1&d0s0=2
RMC> clear alert
RMC> disable modemdef
RMC> enable remote
Modem will be initialized when it is detected
RMC> status
hp AlphaServer TS15 Platform Status
RMC Runtime Firmware Revision: V1.1-0
RMC Booter Firmware Revision: V1.1-0
System Power: ON
System Halt: Deasserted
Escape Sequence: ^[^[RMC
Remote Access: Enabled
Modem RMC Defaults: Disabled
RMC Password: Set
Alerts: Disabled
6-22 hp AlphaServer TS15 Owner's Guide
Status: Not Initialized
Warning Alerts: Disabled