Using The Command-Line Interface - HP AlphaServer TS15 Owner's Manual

6.6

Using the Command-Line Interface

The remote management console supports setup commands and commands for
managing the system. For detailed descriptions of the RMC commands, see Section
6.11.
Command Conventions
Observe the following conventions for entering RMC commands:
•
Enter enough characters to distinguish the command.
NOTE: The reset, quit, and rmcreset commands are exceptions. You must enter the
entire string for these commands to work.
•
For commands consisting of two words, enter the entire first word and enough
characters of the second word to distinguish it from others. For example, you can enter
disable a for disable alert.
•
For commands that have parameters, you are prompted for the parameter.
•
Use the Backspace key to erase input.
•
If you enter a nonexistent command or a command that does not follow conventions,
the following message is displayed:
*** ERROR - Unknown command ***
6-14 hp AlphaServer TS15 Owner's Guide