Table of Contents
Advertisement
Accessing the Front Access Storage Cage
1. Shut down the system and remove the top cover as explained in Section 4.2.
2. Remove the IDE data cable
CD-RW drive.
3. Pull the two spring-loaded posts
.
4. Pull the storage cage back, pivot the rear end up, and remove it from the enclosure.
Turn the cage over to access the remaining cables.
5. Remove the SCSI cable
6. Disconnect the fan cable
top slot area
, except the fan cable, which is routed through the lower slot area
The cage is now completely disconnected.
7. Reverse the procedure (steps 6 to 2) to install the storage cage.
15. Replace the top cover and reassemble the system enclosure as explained in the end of
Section 4.2.
16. Turn on system power by pressing the power switch on the operator control panel. Boot
the operating system.
and power cable
inward so that they come out of the receiving holes
and power cable
.
from the motherboard. All the cables are routed through the
Installing and Configuring Options
from the back of the slimline DVD-
.
4-13
Advertisement
Table of Contents
Troubleshooting
