Pci Configuration Rules For 66 Mhz Modules - HP AlphaServer TS15 Owner's Manual

4.13.2 PCI Configuration Rules for 66 MHz Modules

To run at 66 MHz, the following conditions must be met:
•
Both slot 3 and 4 must be empty.
•
A 33 MHz module must not be installed in either slot 1 or 2.
•
A 66 MHz module must be installed in either slot 1 or 2, otherwise the bus will run at
33 MHz.
•
If a 66 MHz module is installed in slot 3 or 4, it will adjust to run at 33 MHz.
WARNING:
!
appropriate technical training and experience. Such persons are expected to
understand the hazards of working within this equipment and take measures to
minimize danger to themselves or others.
WARNING:
!
See National Electrical Code NFPA 70 or Safety of Information Technology
Equipment, Including Electrical Business Equipment EN 60 950.
!
CAUTION: Check the keying before you install the PCI module and do not force it in.
Plugging a module into a wrong slot can damage it.
To prevent injury, access is limited to persons who have
To prevent fire, use only modules with current limited outputs.
WARNING: High current area. Currents exceeding 240 VA
can cause burns or eye injury. Avoid contact with components.
WARNING: The I/O area houses parts that operate at high
temperatures. To prevent injury, avoid contact with
components.
Installing and Configuring Options 4-29