Outlets - REMEHA Quinta Pro 30 Installation And Service Manual

Quinta Pro 30 - 45 - 65 - 90 - 115
Type Execution
C33 Closed
(2) Closed/Cascade 4
C43
C53 Closed
C63 Closed
Closed
(3)
C83
Closed
(4)
C93
(1) Including the pressure classification P1
(2) EN483: 0,5 mbar suction by pressure reduction
(3) An under pressure of 4 mbar is possible
(4) See table for minimum sizes of duct or sleeving
Type Execution
C93 Diameter
Rigid
100 mm
Flexible
100 mm
Concentric 60/100 mm
80/125 mm
100/150 mm
09/06/2011 - 123157-AF
Description
Exhaust of combustion gases above the roof.
4
The opening for the air-supply inlet is located in the same pressure zone as the vent (For
4
example, a concentric passage to the roof).
Common channelling for the air-supply and exhaust of combustion gases (CLV):
Concentric.
-
Eccentric ; Air supply from the shaft.
-
This also relates to the overpressure cascades.
4
Closed equipment.
4
Separate channelling for the air-supply.
4
Separate channelling for the combustion gases.
4
Terminating on different pressure surfaces.
4
The manufacturer delivers this type of equipment without a supply or exhaust system.
4
The equipment can be connected on a so-called semi-CLV system (with common combustion
4
gas exhaust).
Channel for the air-supply and exhaust fumes in a duct or surrounded by a sleeve:
4
Concentric.
-
Eccentric ; Air supply from the shaft.
-
Exhaust of combustion gases above the roof.
-
The opening for the air-supply inlet is located in the same pressure zone as the vent.
-
Minimum size of the duct or jacket.
∅ Channel
(Without air-supply)
60 mm 110 mm
80 mm 130 mm
160 mm
60 mm 110 mm
80 mm 130 mm
160 mm
120 mm
145 mm
170 mm
∅ Channel
(With air-supply) (Without air-supply)
120 mm 110 x 110 mm
140 mm 130 x 130 mm
170 mm 160 x 160 mm
120 mm 110 x 110 mm
145 mm 130 x 130 mm
170 mm 160 x 160 mm
120 mm 120 x 120 mm
145 mm 145 x 145 mm
170 mm 170 x 170 mm
4.7.2.

Outlets

For exhausting combustion gases of types C1, C3 and C5, it is
appropriate to use a M&G Skyline / Mugro 3000 or a Coxstand E
HR. When exhausting combustion gases of type C6, the material of
the exhaust must conform with Gastec QA and/or be provided with
CE marking.
The exhaust vent for combustion gases must conform to EN
1856-1. The construction of the equipment for exhausting the
combustion gases must be calculated conforming to EN 13384 (parts
1 & 2).
For open exhaust of combustion gases above the roof, the
vent must always be provided with a suitable RVS wire grill.
⃞ Channel ⃞ Channel
(With air-supply)
110 x 110 mm
130 x 130 mm
160 x 160 mm
110 x 110 mm
130 x 130 mm
160 x 160 mm
120 x 120 mm
145 x 145 mm
170 x 170 mm
4. Installation
23