Additional Directives - REMEHA Quinta Pro 30 Installation And Service Manual

Quinta Pro 30 - 45 - 65 - 90 - 115
L
09/06/2011 - 123157-AF
n Connection in areas of different pressure (C53, C83)
Combustion air supply and combustion gas discharge are possible in
various pressure zones, semi-CLV systems. With the exception of
coastal areas. The maximum permissible difference in height
between the combustion air supply and the combustion gas discharge
is 36 m.
Chimney length in the various pressure zones
Diameter
80 mm 20 m
90 mm 36 m
100 mm 36 m
T000780-C
110 mm 36 m
130 mm 36 m
n Reduction table
Pipe reductions per element used
Diameter
80 -125 mm
100 -150 mm
80 mm
90 mm
100 mm
110 mm
130 mm
4.7.4.

Additional Directives

4 Connection of the combustion gas exhaust directly to the buildings
brick chimneys or flues is forbidden for condensation reasons.
4 If flues or chimneys are to be used, they must have an airtight
construction with thick walls and be made from rigid aluminium or
stainless steel. Flexible supply flue pipes made from plastic or
stainless steel are also permissible. Aluminium is permissible only
if there is no contact between the building supply section and the
combustion gas exhaust pipe.
4 Always clean the ducts thoroughly in cases where lining pipes are
used and/or a connection of the air-supply.
4 It must be possible to inspect the flue or chimney.
4 In cases where condensate coming from the stainless steel or
plastic sections of the flue gas pipe can be driven back towards
the aluminium section, this condensate must be removed using a
collecting device before the aluminium section is reached.
Maximum length (L)
Quinta Pro
30 45 65 90
20 m - -
36 m 2 m -
36 m 8 m 4 m
36 m 34 m 32 m
36 m 36 m 36 m
Elbow 45° Elbow 90°
Pipe reduction Pipe reduction
1 m 2 m
1 m 2 m
1.2 m 4.0 m
1.3 m 4.5 m
1.4 m 4.9 m
1.5 m 5.4 m
1.6 m 6.2 m
4. Installation
115
-
-
-
24 m
36 m
25