Outlets; Length Of The Air And Flue Gas Pipes - REMEHA Quinta Pro series Installation, User And Service Manual

Type Version
C93 Concentric
Fig.13 Room-ventilated version
123157 - v.06 - 24022015
Diameter (D)
60/100 mm
80/125 mm
100/150 mm

6.5.2 Outlets

Drain systems (roof feed-through and outside wall feed-through) must be
supplied by the following manufacturers:
Centrotherm
Cox Geelen
Muelink & Grol
Natalini
Poujoulat
Ubbink
Boiler-specific roof and outside wall feed-through kits are also available.

6.5.3 Length of the air and flue gas pipes

With a room-ventilated version, the air supply opening stays open; only the
L
flue gas outlet opening is connected. This will ensure that the boiler ob­
=
tains the necessary combustion air directly from the installation area.
Tab.11 Maximum chimney length (L)
Quinta Pro
AD-0000028-01
30
45
65
90
115
Without air supply
Ø duct □ duct
120 mm 120 x 120 mm
145 mm 145 x 145 mm
170 mm 170 x 170 mm
Note
Where regulations stipulate that a wire grille must be fitted, use a
suitable grille made from stainless steel. There must be a mini­
mum distance of 50 mm between each part of the outlet and the
grille.
Note
Contact us for more information.
Note
When using bends, the maximum chimney length (L) must be
shortened according to the reduction table.
The boiler is also suitable for longer chimney lengths and diam­
eters other than those specified in the tables. Contact us for
more information.
Room-ventilated version (B23, B23P, B33)
Flue gas outlet connection
Air supply connection
Caution
The air supply opening must stay open.
The installation area must be equipped with the necessary air
supply openings. These openings must not be obstructed or
shut off.
80 mm
40 m
33 m
10 m
9 m
8 m
With air supply
Ø duct □ duct
120 mm 120 x 120 mm
145 mm 145 x 145 mm
170 mm 170 x 170 mm
Diameter
90 mm 100 mm
40 m 40 m
40 m 40 m
18 m 27 m
16 m 24 m
12 m 19 m
6 Installation
110 mm
40 m
40 m
40 m
40 m
37 m
25