Planet MH-5000 User Manual page 34

MH-5000 User Manual
FIELD
IP Address
IP Subnet Mask
Enable DHCP Server
IP Pool Starting
Address
Pool Size(max size:
253)
Primary DNS Server
Secondary DNS
Server
Lease time(sec)
Routing Protocol
OSPF Area ID
Step 2. Setup LAN port
Here we are going to configure the LAN1 settings.
Setup IP Address and IP Subnet Mask, and
determine if you would like to enable the DHCP
Server. And then select Routing Protocol. Click
Apply to finish this setting.
FIELD
IP Address
IP Subnet Mask
Enable DHCP Server
DESCRIPTION
DMZ port IP address
DMZ port IP subnet mask
Enable DMZ port of the DHCP Sever or not
Specify the starting address of the DHCP IP address.
Specify the numbers of the DHCP IP address.
Specify the Primary DNS Server IP address of the
DHCP information.
Specify the Secondary DNS Server IP address of the
DHCP information.
Specify DHCP information lease time
Determine to enable the dynamic routing protocol
(RIP), to receive RIP message, to send out RIP
message if the message is received or not.
Specify OSPF area ID number
Table 3-2 Configure DMZ network settings
BASIC SETUP > LAN Settings > LAN1 Status
DESCRIPTION
LAN1 port IP address
LAN1 port IP subnet mask
Enable LAN1 port of the DHCP Sever or not
32
Range / Format EXAMPLE
IPv4 format 10.1.1.254
netmask format 255.255.255.0
Enable/Disable
IPv4 format in
the DMZ
address range
1 ~253
IPv4 format 10.1.1.254
IPv4 format
greater than 0
None / RIPv1In /
RIPv1In+out /
RIPv2In /
RIPv2In+out /
OSPF
IPv4 format or
digit string (Max
9 bits)
Range / Format EXAMPLE
IPv4 format 192.168.40.254
netmask format 255.255.255.0
Enable/Disable
Chapter 3
Basic Setup
Enabled
10.1.1.1
20
0.0.0.0
7200
None
N/A
Enabled