Table of Contents
Advertisement
MH-5000 User Manual
Step 4.
Detail settings of IPSec Manual
Key
For the detailed setting in the Manual Key. We
can press the Advanced button in the previous
page. Then set the parameter separately.
FIELD
Transport Layer
Condition
Protocol
Enable Replay
Action
Detection
Step 5.
Remind to add a Firewall rule
After finishing IPSec rule settings, we need to add
a firewall rule. Here system shows a window
message to remind you of adding a firewall rule.
Just press the OK button to add a firewall rule.
Step 6.
Add a Firewall rule
Same as that in IKE method. Please make sure
that the Firewall is enabled. Select WAN1-to-LAN1
to display the rules of this direction. The default
action of this direction is Block with Logs. We
have to allow the VPN traffic from the WAN1 side
to enter our LAN1 side. So we click the Insert
button to add a Firewall rule before the default
rule.
ADVANCED SETTINGS > VPN Settings > IPSec > Manual Key > Add
> Advanced
DESCRIPTION
Utilize this field to select some packets which
are specified protocol (ANY, TCP, UDP). If
the packets are not the specified protocol will
not be allowed to pass through IPSec tunnels.
Whether is the "Replay Detection" enabled？
Table 13-7 Setup Advanced feature in the IPSec Manual Key rule
ADVANCED SETTINGS > VPN Settings > IPSec > Manual Key > Add
ADVANCED SETTINGS > Firewall > Edit Rules
ANY / TCP / UDP
NO / YES
110
Virtual Private Network – IPSec
Range / Format
Chapter 13
EXAMPLE
ANY
NO
Advertisement
Table of Contents
