Table of Contents
Advertisement
MH-5000 User Manual
Step 3.
Customize the rule
Check the Active checkbox. Enter a name for
this rule like IKErule. Enter the Local IP
(192.168.88.0/255.255.255.0)
Address
and
the
Remote
(192.168.40.0/255.255.255.0). Be sure to
select Aggressive mode to match the WALL-1
settings. Select the Outgoing interface of
this
Device.
Enter
the
opposite-side VPN gateway (61.2.1.1) in the
Peer's IP Address. Click the ESP Algorithm
and select Encrypt and Authenticate (DES,
Enter
the
MD5).
Pre-Shared
1234567890. Select User FQDN (mailbox)
and enter planet.com.tw in My Identifier field.
Click the Apply button to store the settings. Note,
in the Action region, you should choose either
ESP Algorithm or AH Algorithm, or system will
show error message.
Note that one of the Peer's IP Addresses is
Static IP, and the other must be the Dynamic
IP while using Dynamic IPSec VPN type to
establish the VPN tunnel.
Step 4.
Remind to add a Firewall rule
After finishing IPSec rule settings, we need to add
a firewall rule. Here system shows a window
message to remind you of adding a firewall rule.
Just press the OK button to add a firewall rule.
ADVANCED SETTINGS > VPN Settings > IPSec > IKE > Add
IP
Address
public
IP
of
the
Self local IP
as
Key
The opposite
side IP
Address
ADVANCED SETTINGS > VPN Settings > IPSec > IKE > Add
Address
120
Virtual Private Network –Dynamic IPSec
Chapter 14
Advertisement
Table of Contents
