Table of Contents
Advertisement
MH-5000 User Manual
Ans：
Please make sure if you follow the setting method as follows.
a.
Check your IPSec Setting. Please refer to the settings in the Section 13.4- Step 3.
b.
Make sure if you have already added a WAN to LAN policy in the Advanced Settings/Firewall to let the IPSec
packets pass through the MH-5000. (The default value from WAN to LAN is block.).
When you add a Firewall rule, the Source IP and Netmask are the IP address, PrefixLen/Subnet
Mask in the pages of the Remote Address Type. And the Dest IP and Netmask are the IP Address,
PrefixLen/Subnet Mask in the pages of the Local Address Type.
The following Figure B-1, Figure B-2 indicated the WALL_A IPSec and Firewall setting. The Figure B-3, Figure B-4
indicated the opposite side WALL_B IPSec and Firewall setting. When you configure an IPSec policy, please be
sure to add a rule to let the packets of the IPSec pass from WAN to LAN. For the IP address of firewall rules, please
refer to the Figure B-2, Figure B-4.
Figure B-1 WALL_A - Inset a new IPSec policy
Figure B-2 WALL_A - Insert a new firewall rule in WAN to LAN
192
Trouble Shooting
The Local
Address of
WALL_B
Appendix B
Advertisement
Table of Contents
