Table of Contents
Advertisement
MH-5000 User Manual
Step 3.
Customize the rule
Check the Active checkbox. Enter a name for
this rule like IKErule. Enter the Local IP
(192.168.40.0/255.255.255.0)
Address
and
the
Remote
(192.168.88.0/255.255.255.0). Select the
Outgoing Interface of this Device. Select
Dynamic IP in the Peer's IP Address. Be sure to
select Aggressive mode for the dynamic
remote gateway address type. Click the ESP
and
select
Algorithm
Authenticate
(DES,
Pre-Shared Key as 1234567890. Click the
Apply button to store the settings. Note, In the
Action region. It should choose either ESP
Algorithm or AH Algorithm, or system will
show error message. If you hope to set the
detailed item of IKE parameter. Click the
Advanced button in this page. Otherwise it is ok to
just leave the value default.
Note that Peers Identifier must NOT be IP
Address type in the Dynamic IP type. So, you
have to select FQDN (domain name) or user
FQDN (mailbox) as the Peer's Identifier.
Step 4.
Detail settings of IPSec IKE
In this page, we will set the detailed value of IKE
parameter. For the related field, please refer to
Table 13-5
indicated.
ADVANCED SETTINGS > VPN Settings > IPSec > IKE > Add
IP
Address
Self local IP
Encrypt
and
Enter
the
MD5).
The opposite
side IP
Address
ADVANCED SETTINGS > VPN Settings > IPSec > IKE > Add >
Advanced
Address
117
Virtual Private Network –Dynamic IPSec
Chapter 14
Advertisement
Table of Contents
