Connect Devices To The Projector; Projector Connections And Status Leds - Christie CP2215 User Manual

f. Hand-tighten the cathode nut (E). Make sure the smooth portion of the nut is against the
cathode clamp.
g. Tighten the cathode screw (D) with a hex key.
h. Align the ring terminal on the anode wire (B) with the mounting position, ensuring the
crimped side of the wire is facing out.
i. Tighten the anode screw.
j. Route the anode lead away from nearby metal surfaces.
9. Close the lamp access door and tighten the 2 thumbscrews.
10. Close and lock the rear access door.
Make sure the hex key is placed back into its holder before closing the rear access door.

Connect Devices to the Projector

To display content, you must connect a device that is capable of storing or playing content to the
projector.

Projector Connections and Status LEDs

Item
A Indicates the status of the regulator. A solid blue LED indicates the regulator is enabled. If the
LED is not illuminated, the regulator is not enabled.
CP2215 User Manual
020-101225-01 Rev. 1 (01-2014)
Description
Installation and Setup
10