Turn The Projector On; Log On To The Projector - Christie CP2215 User Manual

4. Insert a bare end of the protected earth wire into the hole on the top of the ground lug so it is
beneath the threaded bolt.
5. Tighten the threaded bolt to 50 in-lb.
6. Connect the other bare end of the protected earth wire to the building ground.
7. Connect one end of the projector power cord to the AC receptacle on the lower-left rear corner of
the projector and then connect the other end of the power cord to an AC receptacle.
8. If you are using an Uninterrupted Power Supply (UPS) to power the main electronics, move the
AC switch to A + B and connect the power cord provided with the UPS to the B outlet.

Turn the Projector On

DO NOT attempt to turn the projector on if the AC supply is not within the specified voltage
range. See Power Requirements on page A-3 for power requirements. Failure to comply
could result in death or serious injury.
1. Make sure the circuit breaker for the projector is ON.
2. On the touch panel controller (TPC), tap and hold the green power

Log On to the Projector

1. On the touch panel controller (TPC), tap Menu > Login.
2. Select a user name in the Username list. To view the permissions associated with each account
see User Access Permissions
3. Enter your password.
4. Tap Login.
CP2215 User Manual
020-101225-01 Rev. 1 (01-2014)
on page 57.
Installation and Setup
icon.
15