Christie CP2215 User Manual page 89

reflector and guide the lamp onto the cathode clamp. Be careful not to hit the lamp against the
reflector.
5. Thread on and hand-tighten the cathode nut. Make sure the smooth portion of the nut is against
the cathode clamp.
6. Tighten the cathode clamp (F) with a hex key.
7. Align the ring terminal on the anode wire (B) with the mounting position ensuring the crimped
side of the wire is facing out. Tighten the anode screw.
Route anode lead away from nearby metal surfaces.
8. Close the lamp access door and tighten the 2 thumbscrews.
9. Close and lock the rear access door. Make sure the hex key is placed back into its holder before
closing the rear access door.
10. Connect the projector to AC power and then turn the projector on.
11. Tap Menu > Advanced Setup > Lamp Change Wizard.
12. Tap Next.
13. Complete these fields:
Field
Type
Serial Number
Reason for Change
Lamp Expiry (Hours)
Hours Used
14. Tap Save.
15. Tap Next.
16. Align the lamp. See
CP2215 User Manual
020-101225-01 Rev. 1 (01-2014)
The lamp type.
The lamp serial number.
The reason the lamp was changed.
The number of hours the lamp can operate before replacement.
This field is auto-populated.
The number of hours the lamp has operated before installation.
Align the Lamp with LampLOC
Description
on page 17.
Maintenance
81